AUS/NZ ONLY Pegasus - Poster Print
Available in three sizes - A1, A2 and A3
A1 - 59.4cm x 84.1cm / 23.39" x 33.11" - AVAILABLE AUS & NZ ONLY
A2 - 42.0cm x 59.4cm / 16.5" x 23.4" - AVAILABLE NZ ONLY
A3 - 29.7cm x 42.0cm / 11.7" x 16.5" - AVAILABLE AUS & NZ ONLY
*Available in AUS/NZ Only
- Plan your placement of the poster on your project
- Apply Mod Podge or PVA glue to the back of the print and directly onto your project with brush or roller.
- Place your poster on your project and smooth out any air bubbles using our self adhesive decoupage blue tool.
- Push the air bubbles out from the centre of the project towards the sides using the felt side of our self adhesive decoupage blue tool, so as not to damage the image.
- Your print comes with a protective film on it so only the edges and any cuts or penetrations piercing the film, require sealing. If you would like to seal the print to achieve the same finish as your piece of furniture, apply one THIN coat of water based polyurethane sealer or top coat before applying any other finishes.
- DO NOT apply PVA glue on the print surface as you would with other styles of decoupage.
- DO NOT apply any irons, heat or water.
Always use a water based sealer or topcoat!